Difference between revisions of "Diesel Version 5:CV 16.0.260"
Jump to navigation
Jump to search
| (2 intermediate revisions by the same user not shown) | |||
| Line 4: | Line 4: | ||
|cv range=0-255 | |cv range=0-255 | ||
|cv accepted=Any | |cv accepted=Any | ||
| − | |cv default= | + | |cv default=77 |
}} | }} | ||
==NMRA CV 16.0.260 DC Mode Regulated Supply Automatic Bell Cutout Voltage== | ==NMRA CV 16.0.260 DC Mode Regulated Supply Automatic Bell Cutout Voltage== | ||
| − | This CV sets the voltage level above which the DC mode automatic bell will stop playing while the decoder is in "Regulated" DC power supply mode. The higher the value in this CV, the higher the throttle must be set to before the automatic bell turns off. The DC mode automatic bell will come on when the locomotive starts moving, turn off when the setpoint is reached, and turn back on when the voltage goes below that voltage again. The DC mode automatic bell must first be enabled via [[{{NAMESPACE}}:CV_181|CV181 - DC Mode Sounds CV]]. | + | This CV sets the voltage level above which the DC mode automatic bell will stop playing while the decoder is in "Regulated" DC power supply mode. The higher the value in this CV, the higher the throttle must be set to before the automatic bell turns off. The DC mode automatic bell will come on when the locomotive starts moving, turn off when the setpoint is reached, and turn back on when the voltage goes below that voltage again. The DC mode automatic bell must first be enabled via [[{{NAMESPACE}}:CV_181|CV181 - DC Mode Sounds CV]]. |
| − | + | ||
==Related== | ==Related== | ||
| Line 15: | Line 15: | ||
*DC Mode Power Supply Mode Selection | *DC Mode Power Supply Mode Selection | ||
*[[{{NAMESPACE}}:CV_16.0.274|NMRA Indexed CV 16.0.274]] - DC Mode Unregulated Supply Automatic Bell Cutout Voltage | *[[{{NAMESPACE}}:CV_16.0.274|NMRA Indexed CV 16.0.274]] - DC Mode Unregulated Supply Automatic Bell Cutout Voltage | ||
| + | |||
| + | [[Category:DC_Mode]][[Category:Indexed_CV]] | ||
Latest revision as of 00:29, 30 December 2020
| |||||||||
NMRA CV 16.0.260 DC Mode Regulated Supply Automatic Bell Cutout Voltage
This CV sets the voltage level above which the DC mode automatic bell will stop playing while the decoder is in "Regulated" DC power supply mode. The higher the value in this CV, the higher the throttle must be set to before the automatic bell turns off. The DC mode automatic bell will come on when the locomotive starts moving, turn off when the setpoint is reached, and turn back on when the voltage goes below that voltage again. The DC mode automatic bell must first be enabled via CV181 - DC Mode Sounds CV.
Related
- DC Mode Operation
- DC Mode Power Supply Mode Selection
- NMRA Indexed CV 16.0.274 - DC Mode Unregulated Supply Automatic Bell Cutout Voltage
