CV 8| Manufacturer ID |
|---|
| Range of Values | 0-255 |
|---|
| Accepted Values | None |
|---|
| Default Value | 153 |
|---|
|
NMRA CV 8 - Manufacturer ID
CV8 contains the NMRA-assigned ID number of the manufacturer of this decoder. The currently assigned manufacturer ID codes are listed under the Standards section of the NMRA Website. The use of a value not assigned by the NMRA will immediately cause the decoder to not be in conformance of the NMRA Standards.
Train Control Systems' Manufacturer ID Number is 153.
CV 8 is classified as a Read Only CV. The CV contains a value which cannot be overwritten; however, it is possible to "write" a value to this CV. Doing so may perform a "Macro" such as a Factory Reset, or other operation(s). See below some examples from TCS:
CV 8 "Macros"
CV 8 offers multiple "macro" options which allow you to quickly configure certain aspects of the decoder on the fly. Most macros will perform a sequence of operations internally within the decoder, meaning you would not need to perform each of those operations individually, and can instead use one single command. CV 8 can also be used to save and load User Presets, perform a factory reset, and more!
CV 8 Macros may be programmed on the mainline or a programming track; however, it is strongly recommended that you use a dedicated programming track when performing a factory reset so as to avoid any addressing conflicts.
Available Macros
TCS Non-Sound Version 88-91
| Value
|
Macro/Operation
|
| 2
|
Factory Reset (Excluding ULST)
|
| 3-9
|
Not Used
|
| 10
|
Configure F1 and F2 Ditch Lights
|
| 11
|
Configure Trolley Preset
|
| 12
|
Configure "Deluxe" Trolley Preset
|
TCS Non-Sound Version 92
| Value
|
Macro/Operation
|
| 2
|
Factory Reset (Excluding ULST)
|
| 3-7
|
Not Used
|
| 8
|
Factory Reset (Excluding ULST)
|
| 10
|
Configure F1 and F2 Ditch Lights
|
| 11
|
Configure Trolley Preset
|
| 12
|
Configure "Deluxe" Trolley Preset
|
WOWSound Version 4
| Value
|
Macro/Operation
|
| 2
|
Factory Reset (Excluding ULST)
|
| 3-9
|
Not Used
|
| 10
|
Configure F1 and F2 Ditch Lights
|
| 11
|
Configure Trolley Preset
|
| 12
|
Configure "Deluxe" Trolley Preset
|
| 13
|
Set Throttle Mode to "Traditional"
|
| 14
|
Set Throttle Mode to "Prototype"
|
WOWSound Version 5
| Value
|
Macro/Operation
|
| 2
|
Factory Reset
|
| 3
|
Reset Sound Button Mappings
|
| 4
|
Reset all NMRA CV's (1-256)
|
| 5
|
Reset all Indexed CV's
|
| 6
|
Factory Reset only 128-point BEMF Table
|
| 8
|
Factory Reset
|
| 10
|
Load User Preset 1
|
| 11
|
Load User Preset 2
|
| 12
|
Load User Preset 3
|
| 15
|
Configure F1 and F2 outputs as Ditch Lights
|
| 11+
|
[Reserved]
|