CV 27| Automatic Stopping Configuration |
|---|
| Range of Values | 0-255 |
|---|
| Accepted Values | 0-63 |
|---|
| Default Value | 0 |
|---|
|
NMRA CV 27 - Decoder Automatic Stopping Configuration
Used to configure which actions will cause the decoder to automatically stop.
Bit 0 = Enable/Disable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the
right rail.
| Feature
|
Value
|
| Function 1
|
1
|
| Function 2
|
2
|
| Function 3
|
4
|
| Function 4
|
8
|
| Function 5
|
16
|
| Function 6
|
32
|
| Function 7
|
64
|
| Function 8
|
128
|
“0” = Disabled “1” = Enabled
Bit 1 = Enable/Disable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the left rail.
“0” = Disabled “1” = Enabled
Bit 2 = Enable/Disable Auto Stop in the presence of an Signal Controlled Influence cutout signal.
“0” = Disabled “1” = Enabled
Bit 3 = Reserved for Future Use
Bit 4 = Enable/Disable Auto Stop in the presence of reverse polarity DC
“0” = Disabled “1” = Enabled
Bit 5 = Enable/Disable Auto Stop in the presence forward polarity DC.
“0” = Disabled “1” = Enabled
Bits 6-7 = Reserved for future use.
- Note If the decoder does not support a feature contained in this table, it shall not allow the corresponding bit to be set improperly (i.e. the bit should always contain it’s default value).