LT Panel

LT Panel
Device Information Manufacturer Train Control Systems Type Fascia Panel SKU 1599 Release Date 08-09-2022 Retail Price $29.95 PSU DC 15V/36W (Not Incl.)

The LT Panel is the same fascia panel assembly which comes included with the LT-50.

This product is an expansion panel for an LCC network, such as those created and used by the CS-105 and LT-50. Use this product to expand the number of wired throttles such as the T-50 you can connect to the TCS command station, or to provide an access point and/or power for other LCC devices distributed around your layout.

The LT Panel also includes a jack you can use to connect a Power Supply to power the LCC bus. (Not Included, except with LT-50)

Included In Package

• LT Panel board x1
• LT Panel fascia cover plate x1
• Fascia mounting screws x4
• Fascia cover plate screws x2
• Option Jumpers x3

Physical Overview

The LT Panel has a few notable physical features:

1. Green 2-pin Track Output connector with detachable screw terminal connector
2. 2.5mm x 5.5mm barrel jack for Power In
3. Configuration Jumpers (see details below)
4. Single "LT" RJ-45 jack(for LT-50 only)
5. Three "LCC" RJ-45 jacks (1x Front: For T-50; 2x Rear for LCC Bus)
6. Bi-color LED for "Track On"

Configuration Jumpers

Refer to the table below for information on the configuration jumpers available on the LT Panel:

Jumper Position	Description
TERM (1)	Insert this jumper to add termination to the LCC-CAN bus. An LCC-CAN bus should have exactly two terminators, with one at each end of the bus. This jumper can (optionally) provide for one of the required terminators. Note: In practicality, a very short (less than 10ft or 3m) LCC-CAN bus can still work reliably with one terminator.
N/A (2)	Not Used
Template:Nowrap	The LT Panel is designed to be use with a "Layout Throttle", such as an LT-50, plugged into the front facing port with the "LT" logo. Simplified diagram showing the electrical connection for DCC/F jumpers. Insert these two jumpers to pass the low power DCC signals from the Layout Throttle through to the other three LCC jacks (pins 4 & 5 of the LCC-CAN standard). Remove these jumpers to disconnect the low power DCC signals provided by the Layout Throttle. Note: The Layout Throttle uses the NMRA S-9.1.2 Full Scale Interface DCC/F is a low-power mirror of the track output from the command station (in this case, the LT-50). This circuit is only intended to be used to provide the signal from the LT-50 to other devices on the LCC-CAN bus. This circuit is not intended to supply signals to LCC boosters such as the B-106. This circuit must be disabled/open if another LCC device is driving the LCC-CAN pins 4 & 5 as allowed by the standard. The LT Panel is not designed to be used along with another LCC/DCC command station, such as the CS-105. In this case, an LCC Panel should be used instead.