LT Panel

The LT Panel is the same fascia panel assembly which comes included with the LT-50.

This product is an expansion panel for an LCC network, such as those created and used by the CS-105 and LT-50. Use this product to expand the number of wired throttles such as the T-50 you can connect to the TCS command station, or to provide an access point and/or power for other LCC devices distributed around your layout.

The LT Panel also includes a jack you can use to connect a Power Supply to power the LCC bus. (Not Included, except with LT-50)

Included In Package

• LT Panel board x1
• LT Panel fascia cover plate x1
• Fascia mounting screws x4
• Fascia cover plate screws x2

Physical Overview

The LT Panel has a few notable physical features:

1. Green 2-pin Track Output connector with detachable screw terminal connector
2. 2.5mm x 5.5mm barrel jack for Power In
3. Configuration Jumpers (see details below)
4. Single "LT" RJ-45 jack(for LT-50 only)
5. Three "LCC" RJ-45 jacks (1x Front: For T-50; 2x Rear for LCC Bus)
6. Bi-color LED for "Track On"

Configuration Jumpers

Refer to the table below for information on the configuration jumpers available on the LT Panel:

Jumper Position	Description
(1) TERM	Insert this jumper to add termination to the LCC-CAN bus. An LCC-CAN bus should have exactly two terminators, with one at each end of the bus. This jumper can (optionally) provide for one of the required terminators. Note: In practicality, a very short (less than 10ft or 3m) LCC-CAN bus can still work reliably with one terminator.
(2) N/A	Not Used
(3 & 4) DCC/F	Simplified diagram showing the electrical connection for DCC/F jumpers. Insert these two jumpers to pass the low power DCC signals through the LCC panel (pins 4 & 5 of the LCC-CAN standard). Remove these jumpers to disconnect the low power DCC signals from passing through the panel. Note: The LT Panel uses the NMRA S-9.1.2 Full Scale Interface