Difference between revisions of "Diesel Version 5:CV 27"
Jump to navigation
Jump to search
m |
m (NOT SUPPORTED NOTE) |
||
| Line 66: | Line 66: | ||
''Note If the decoder does not support a feature contained in this table, the decoder shall not allow the corresponding bit to be set improperly (i.e. the bit should always contain it’s default value).'' | ''Note If the decoder does not support a feature contained in this table, the decoder shall not allow the corresponding bit to be set improperly (i.e. the bit should always contain it’s default value).'' | ||
| + | |||
| + | '''THIS FEATURE IS NOT CURRENTLY SUPPORTED''' | ||
Revision as of 23:14, 22 May 2021
| |||||||||
NMRA CV 27 - Decoder Automatic Stopping Configuration
This CV is used to configure which conditions on the rails will cause the decoder to automatically stop.
| Bit | Option | Value | Default |
|---|---|---|---|
| 0 | Set to Enable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the right rail | 1 | OFF |
| 1 | Set to Enable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the left rail | 2 | OFF |
| 2 | Set to Enable Auto Stop in the presence of an Signal Controlled Influence cutout signal | 4 | OFF |
| 3 | [Reserved/Not Used] | N/A | |
| 4 | Set to Enable Auto Stop in the presence of reverse polarity DC | 16 | OFF |
| 5 | Set to Enable Auto Stop in the presence forward polarity DC | 32 | OFF |
| 6 | [Reserved/Not Used] | N/A | |
| 7 | [Reserved/Not Used] | N/A |
Note If the decoder does not support a feature contained in this table, the decoder shall not allow the corresponding bit to be set improperly (i.e. the bit should always contain it’s default value).
THIS FEATURE IS NOT CURRENTLY SUPPORTED
