Difference between revisions of "Diesel Version 5:CV 27"
Jump to navigation
Jump to search
m |
m |
||
| Line 2: | Line 2: | ||
|cv name= Automatic Stopping Config. | |cv name= Automatic Stopping Config. | ||
|cv range=0-255 | |cv range=0-255 | ||
| − | |cv accepted=0- | + | |cv accepted=0-55 |
|cv default=0 | |cv default=0 | ||
}} | }} | ||
Revision as of 23:12, 22 May 2021
| |||||||||
NMRA CV 27 - Decoder Automatic Stopping Configuration
This CV is used to configure which conditions on the rails will cause the decoder to automatically stop.
| Bit | Option | Value | Default |
|---|---|---|---|
| 0 | Set to Enable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the right rail | 1 | OFF |
| 1 | Set to Enable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the left rail | 2 | OFF |
| 2 | Set to Enable Auto Stop in the presence of an Signal Controlled Influence cutout signal | 4 | OFF |
| 3 | [Reserved/Not Used] | N/A | |
| 4 | Set to Enable Auto Stop in the presence of reverse polarity DC | 16 | OFF |
| 5 | Set to Enable Auto Stop in the presence forward polarity DC | 32 | OFF |
| 6 | [Reserved/Not Used] | N/A | |
| 7 | [Reserved/Not Used] | N/A |
Note If the decoder does not support a feature contained in this table, the decoder shall not allow the corresponding bit to be set improperly (i.e. the bit should always contain it’s default value).
