Difference between revisions of "Diesel Version 5:CV 27"
Jump to navigation
Jump to search
m (made this page easier to understand using a table) |
m |
||
| Line 1: | Line 1: | ||
{{Infobox CV | {{Infobox CV | ||
| − | |cv name= Automatic Stopping | + | |cv name= Automatic Stopping Config. |
|cv range=0-255 | |cv range=0-255 | ||
|cv accepted=0-63 | |cv accepted=0-63 | ||
Revision as of 23:11, 22 May 2021
| |||||||||
NMRA CV 27 - Decoder Automatic Stopping Configuration
This CV is used to configure which conditions on the rails will cause the decoder to automatically stop.
| Bit | Option | Value | Default |
|---|---|---|---|
| 0 | Set to Enable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the right rail | 1 | OFF |
| 1 | Set to Enable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the left rail | 2 | OFF |
| 2 | Set to Enable Auto Stop in the presence of an Signal Controlled Influence cutout signal | 4 | OFF |
| 3 | [Reserved/Not Used] | N/A | |
| 4 | Set to Enable Auto Stop in the presence of reverse polarity DC | 16 | OFF |
| 5 | Set to Enable Auto Stop in the presence forward polarity DC | 32 | OFF |
| 6 | [Reserved/Not Used] | N/A | |
| 7 | [Reserved/Not Used] | N/A |
Note If the decoder does not support a feature contained in this table, the decoder shall not allow the corresponding bit to be set improperly (i.e. the bit should always contain it’s default value).
