Diesel Version 5:CV 8

From Train Control Systems Documentation
Revision as of 22:23, 23 July 2021 by TCSDanM (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
CV 8
Manufacturer ID
Range of Values0-255
Accepted ValuesNone
Default Value153

NMRA CV 8 - Manufacturer ID

CV8 contains the NMRA-assigned ID number of the manufacturer of this decoder. The currently assigned manufacturer ID codes are listed under the Standards section of the NMRA Website. The use of a value not assigned by the NMRA will immediately cause the decoder to not be in conformance of the NMRA Standards.

Train Control Systems' Manufacturer ID Number is 153.

CV 8 is classified as a Read Only CV. The CV contains a value which cannot be overwritten; however, it is possible to "write" a value to this CV. Doing so may perform a "Macro" such as a Factory Reset, or other operation(s). See below some examples from TCS:

CV 8 "Macros"

CV 8 offers multiple "macro" options which allow you to quickly configure certain aspects of the decoder on the fly. Most macros will perform a sequence of operations internally within the decoder, meaning you would not need to perform each of those operations individually, and can instead use one single command. CV 8 can also be used to save and load User Presets, perform a factory reset, and more!

CV 8 Macros may be programmed on the mainline or a programming track; however, it is strongly recommended that you use a dedicated programming track when performing a factory reset so as to avoid any addressing conflicts.

Available Macros

TCS Non-Sound Version 88-91
Value Macro/Operation
2 Factory Reset (Excluding ULST)
10 Configure F1 and F2 Ditch Lights
11 Configure Trolley Preset
12 Configure "Deluxe" Trolley Preset
TCS Non-Sound Version 92
Value Macro/Operation
2 Factory Reset (Excluding ULST)
8 Factory Reset (Excluding ULST)
10 Configure F1 and F2 Ditch Lights
11 Configure Trolley Preset
12 Configure "Deluxe" Trolley Preset
WOWSound Version 4
Value Macro/Operation
2 Factory Reset (Excluding ULST)
10 Configure F1 and F2 Ditch Lights
11 Configure Trolley Preset
12 Configure "Deluxe" Trolley Preset
WOWSound Version 5
Value Macro/Operation
2 Factory Reset
3 Reset Sound Button Mappings
4 Reset all NMRA CV's (1-256)
5 Reset all Indexed CV's
6 Factory Reset only 128-point BEMF Table
8 Factory Reset
10 Load User Preset 1
11 Load User Preset 2
12 Load User Preset 3
15 Configure F1 and F2 outputs as Ditch Lights
11+ [Reserved]