TCSDanM: 1 revision imported

2021-07-16T21:47:56Z

1 revision imported

← Older revision	Revision as of 21:47, 16 July 2021
(No difference)

tcs>TCSDanM at 21:13, 16 July 2021

2021-07-16T21:13:54Z

New page

{{Infobox CV
|cv name= Automatic Stopping Config.
|cv range=0-255
|cv accepted=0-55
|cv default=0
}}

==NMRA CV 27 - Decoder Automatic Stopping Configuration==
This CV is used to configure which conditions on the rails will cause the decoder to automatically stop.

{| class="wikitable" style="text-align: center;"
|-
! scope="col" |Bit
! scope="col" |Option
!Value
!Default
|-
! scope="row" |0
|Set to Enable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the right rail
|1
|OFF
|-
|-
! scope="row" |1
|Set to Enable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the left rail
|2
|OFF
|-
|-
! scope="row" |2
|Set to Enable Auto Stop in the presence of an Signal Controlled Influence cutout signal
|4
|OFF
|-
|-
! scope="row" |3
|[Reserved/Not Used]
|
|N/A
|-
|-
! scope="row" |4
|Set to Enable Auto Stop in the presence of reverse polarity DC
|16
|OFF
|-
|-
! scope="row" |5
|Set to Enable Auto Stop in the presence forward polarity DC
|32
|OFF
|-
|-
! scope="row" |6
|[Reserved/Not Used]
|
|N/A
|-
|-
! scope="row" |7
|[Reserved/Not Used]
|
|N/A
|-
|}

''Note If the decoder does not support a feature contained in this table, the decoder shall not allow the corresponding bit to be set improperly (i.e. the bit should always contain it’s default value).''

'''THIS FEATURE IS NOT CURRENTLY SUPPORTED'''
[[Category:Standard CV]][[Category:Unsupported CV]]

CV 27 - Revision history

TCSDanM: 1 revision imported

tcs>TCSDanM at 21:13, 16 July 2021